Honeywell X-618 Installation Manual page 29

Public address system

Hide thumbs Also See for X-618:

Table of Contents

Insert the prepared noise detector connection cable into the corresponding input wiring

terminal (8P) and tighten the screws.

Insert the wiring terminal of the installed cable into the DCS supervision port.

Connect the Speaker Line of noise detector to the area.

Fix the noise detector and if there are many detectors in a same line, please follow the

connection method shown in Figure 21.

Choose a fix method based on the surrounding situation. It can be embedded in ceiling or

install it though hanging.

If the appearance of noise detector is similar to the end-of-line supervision module, installation

can be conducted according to corresponding method.

Figure 21 Schematic Diagram of the X-DCS3000 Connection to the Noise Detector

Connecting Module X-EOL

End of line supervision modules and noise detectors may be installed on the same line- see the

following steps:

Open the cover, set module address 1 to 5 according to binary code and switch address 1 to

ON position, which is shown as below.

Table of Contents

X-dcs3000