Honda XRE300 Owner's Manual page 117

20
(8) PGM-FI malfunction
indicator lamp (MIL)
(amber)
(9) Turn signal indicator (green)
(10) High beam indicator (blue)
(11) Anti-lock Brake System (ABS)
indicator (amber) (XRE300A)
(12) RESET button
(13) SEL button
Lights when there is any abnormality in the PGM-FI (Programmed
Fuel Injection) system. Should also light for a few seconds
and then go off when the ignition switch is turned ON and
engine stop switch is at
at any other time, reduce speed and take the motorcycle
to a Honda dealer as soon as possible.
Flashes when the either turn signal operates.
Lights when the headlight is on high beam.
This indicator normally comes on when the ignition switch is
turned ON, and goes off after you ride the motorcycle at speed
above 10 km/h (6 mph). If there is a problem with the Anti-lock
Brake System (ABS), this indicator lights or flashes and remains
on (page 49).
This button is used to reset the tripmeter (page 22) or to adjust
the time (page 22).
This button is used to reset the tripmeter or to select the tripmeter
and odometer (page 22). This button is also used to adjust the
time (page 22).
XRE300 · XRE300A
(RUN). If the indicator comes on