Upper Cutter Position; 2-Thread Overlock Converter - Husqvarna VIKING Amber Air S 600 User Manual

Upper Cutter Position

Turn off the main power switch and unplug the machine.
Deactivate the Upper Cutter, Position B
Deactivate the upper cutter for flatlock, coverstitch and
chainstitch or other sewing where the fabric shall not be cut.
Open the front cover.
Turn the handwheel toward you until the upper cutter (A) is
raised to the highest position.
Pull the upper cutter knob (B) to the right as far as it will go.
Turn the knob towards you, until the cutter clicks into the
locked position B (C).
Activate the Upper Cutter, Position A
Open the front cover.
Pull the movable cutter knob to the right as far as it will go.
Turn the knob away from you, until the cutter clicks into the
cutting position A (D).
2–Thread Overlock Converter
2-thread overlock stitches are sewn using one needle thread
and the lower looper thread. Before sewing, the 2-thread
coverter must be engaged.
The 3-thread stretch overlock stitch is also sewn with the 2-
thread overlock converter engaged.
Turn off the main power switch and unplug the machine
Engage the 2–Thread Overlock Converter
Open the front cover.
Flip the 2–thread converter (A) to the left over the upper
looper. Push the tip of the converter backwards carefully, and
insert the sharp edge (B) of the converter in the eye (C) at the
rear of the upper looper.
Disengage the 2–Thread Overlock Converter
Carefully push the 2–thread converter backwards and remove
the sharp edge from the eye of the upper looper. Flip the
converter to the right until it is in the disengaged position.
A A
A A
2 Preparations
B
A B A C
A C
A D
15