Oiling; Replace The Upper Cutter; Storage; Servicing - Husqvarna VIKING Amber Air S 600 User Manual

Oiling

Turn off the main power switch and unplug the machine.
To keep the machine running smoothly and quietly the
moving parts (on the upper looper), pointed out in the
picture, must be lubricated often. We recommend lubricating
once a week for normal use or once every 10 hours of
continuous use.
Use sewing machine oil. Do not use any other oil, it could
damage the machine.
With the machine unthreaded, place a scrap of fabric under
the presser foot and run the machine for a few minutes.
Wipe the machine surface to remove all excess oil before
sewing.
Important when oiling!
Never inject oil into the looper threader holes, the
pipe openings or the looper tips (marked in red in
the picture).

Replace the Upper Cutter

Turn off the main power switch and unplug the machine.
The movable upper cutter should be changed when it
becomes dull. The upper cutter can be replaced according to
the following directions. If you are having any difficulties,
consult your authorized service technician.
Open the front cover and set the movable upper cutter (A) in
A position (see page 15).
Loosen the set screw (B), by turning it towards you, and
remove the upper cutter.
Turn the handwheel until the upper cutter holder is in its
lowest position.
Place a new upper cutter in the groove of the upper cutter
holder and tighten the set screw (C).
Make sure the front edge of the movable upper cutter is 0.5-
1.0 mm lower than the cutting edge of the stationary cutter
(D).

Storage

When the machine is not in use, be sure to keep it unplugged. Cover the machine with the soft dust cover to protect it and store
the machine, so it is not exposed to direct sunlight or humidity.

Servicing

If you have any questions regarding service and/or operation, contact our Customer Care department.
A A
0.5-1.0mm
7 Maintenance
B
A D
A C
57