For Vigorpro5300N - Draytek VigorPro 5300 Quick Start Manual

1 . 1 . 2 F o r V i g
1 . 1 . 2 F o r V i g
LED
ACT (Activity)
IDP (Intrusion Detection and
Prevention)
Virus
WLAN
WAN1/2
MGMT
VPN
QoS
LED on Connector
WAN 1/2
LAN 1/2/3/4
4
o r P r o 5 3 0 0 n
o r P r o 5 3 0 0 n
Status
Blinking
Off
On
(Yellow)
On
(Yellow)
On
Blinking
On
Blinking
On
Blinking
On
On
Left LED On
(Green)
Off
Blinking
Right LED On
(Green)
Off
Left LED On
(Green)
Off
Blinking
Right LED On
(Green)
Off
Explanation
The router is powered on and running normally.
The router is powered off.
The anti-intrusion function is enabled.
The anti-virus function is enabled.
Wireless access point is ready.
It will blink slowly while wireless traffic goes
through.
If ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and it will
return to normal condition after two minutes. (You
need to setup WPS within 2 minutes.)
The WAN1 or WAN2 connection is ready.
It will blink while transmitting data.
The router is managed (handled) by Telnet.
It will blink while being managed by IE browser.
The VPN tunnel is active.
The QoS function is active.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is connected with 10Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is connected with 10Mbps.
VigorPro 5300 Series Quick Start Guide