Overhead Console Reading Lamps; Rear Assist Handle Reading Lamps; Electric Power Management - Buick Automobile User Manual

Overhead Console Reading Lamps

Your vehicle may have reading lamps located on
the overhead console. Press the lens to turn them on
and off.

Rear Assist Handle Reading Lamps

Your vehicle may have reading lamps located near
the rear assist handles. Press the lens to turn them on
and off.

Electric Power Management

The vehicle has Electric Power Management (EPM) that
estimates the battery's temperature and state of
charge. It then adjusts the voltage for best performance
and extended life of the battery.
When the battery's state of charge is low, the voltage is
raised slightly to quickly put the charge back in. When the
state of charge is high, the voltage is lowered slightly to
prevent overcharging. If the vehicle has a voltmeter gage
or voltage display on the Driver Information Center (DIC),
you may see the voltage move up or down. This is
normal. If there is a problem, an alert will be displayed.
3-18
The battery can be discharged at idle if the electrical
loads are very high. This is true for all vehicles. This is
because the generator (alternator) may not be
spinning fast enough at idle to produce all the power
that is needed for very high electrical loads.
A high electrical load occurs when several of the
following loads are on: headlamps, high beams, fog
lamps, rear window defogger, climate control fan at high
speed, heated seats, engine cooling fans, trailer
loads, and loads plugged into accessory power outlets.
EPM works to prevent excessive discharge of the
battery. It does this by balancing the generator's output
and the vehicle's electrical needs. It can increase
engine idle speed to generate more power, whenever
needed. It can temporarily reduce the power demands of
some accessories.
Normally, these actions occur in steps or levels, without
being noticeable. In rare cases at the highest levels
of corrective action, this action may be noticeable to the
driver. If so, the Driver Information Center (DIC)
message might display Battery Saver Active. If this
message is displayed, it is recommended that the driver
reduce the electrical loads as much as possible. See
DIC Warnings and Messages on page 3-58.