Table of Contents
Advertisement
6. Have one person grasp both sides of the device, lift it, and position it in the rack so that the front bracket is aligned
with the rack holes.
7. Have a second person secure the front of the device to the rack by using 4 mounting screws (and cage nuts and washers
if your rack requires them). Tighten the screws. See
Figure 3: Attach the PTX10001-36MR to the Rack
8. Continue to support the PTX10001-36MR while sliding the rear mounting blades into the channel of the side mounting
rails and securing the blades to the rack. Use four mounting screws (and cage nuts and washers if your rack requires
them) to attach the blade to the rack. Tighten the screws. See
Figure 4: Slide Mounting Blades into Mounting Rail
9. Ensure that the PTX10001-36MR chassis is level by verifying that all the screws on the front of the rack are aligned
with the screws at the back of the rack.
To mount the PTX10001-36MR on two posts in a rack by using the two-post mounting kit that you purchased separately:
1. Wrap and fasten the ESD grounding strap to your bare wrist and an connect the other end of the strap to the ESD
point on the device.
2. Decide whether to place the front (port) end or the back (FRU) end of the PTX10001-36MR at the front of the rack.
Position the PTX10001-36MR in such a manner that the AIR OUT labels on components are next to the hot aisle.
3. Align the hooks and the screw holes on the mounting bracket with the screw holes on the side of the chassis. See
Figure 5
to see the proper alignment for the PTX10001-36MR.
Figure
3.
Figure
4.
6
Advertisement
Table of Contents
