Husqvarna FE 350 2021 Owner's Manual page 136

18 SERVICE WORK ON THE ENGINE
134
Main work
–
Position an appropriate container under the engine.
–
Remove oil drain plug
Info
Do not remove screws
V01393-10
–
Remove screw plug
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
V01394-10
–
Position oil screen
–
Position the pin wrench through the drill hole of the screw
plug in the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
V01395-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil
screen
–
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
V01396-10
magnet
–
Remove screws
ring.
V01397-10
1
with the magnet and seal ring.
2
.
3 4
with oil screen and the O-rings.
4
with the O-rings on a pin wrench.
3
with the O-ring.
M20x1.5 15 Nm (11.1 lbf ft)
1
with the magnet and a
M12x1.5 20 Nm (14.8 lbf ft)
5
. Remove the oil filter cover with the O-