Husqvarna FE 350 2021 Owner's Manual page 101

–
Stand the vehicle upright.
–
Remove the cable tie on the frame protector.
–
Remove screw cap
H03724-01
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does not
flow out of the brake fluid reservoir; extract some if neces-
sary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
ton.
H03727-10
–
Remove cotter pin
–
Push spring plate
–
Take out the brake linings.
–
Clean the brake caliper and brake caliper bracket.
–
Check that spring plate
6
plate in the brake caliper bracket are seated correctly.
H03728-10
–
Insert the new brake linings.
–
5
Mount pin
Spring plate
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
the piston side brake lining.
H03729-10
–
Mount cotter pins
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
BRAKE SYSTEM 13
1 2
with membrane
3
.
4
downwards and remove pin
4
in the brake caliper and sliding
.
4
engages in the groove on the pin.
7
3
.
and the shim.
5
.
is mounted on
99