Ethernet Interface Commands; Set Clientsta Bridge-Mip; Set Clientsta Bridge-Static-Ip - Alvarion BreezeACCESS-EZ Manual

5.8

Ethernet Interface Commands

The commands described in this section configure connection parameters for the
Ethernet port.
Command Function
set ClientSta Sets the subnet mask for the unit.
bridge-mip
set ClientSta Sets the IP address for the unit.
bridge-static-ip
set ClientSta Sets the default gateway for passing traffic to the unit.
default-gw
set ClientSta Enables/disables DHCP on the unit.
dhcpc
5.8.1

set ClientSta bridge-mip

This command sets the subnet mask for the interface.
Syntax
set ClientSta bridge-mip <subnet mask>
• subnet mask - The mask that identifies the host address bits used for routing to specific
subnets. Specified as four decimal numbers, 0 to 255, separated by periods
Default Setting
255.0.0.0
Command Mode
Installer, Admin
Example
Installer# set ClientSta bridge-mip 255.255.255.0
Installer#
5.8.2

set ClientSta bridge-static-ip

This command sets the IP address for the interface.
Syntax
set ClientSta bridge-static-ip <IP address>
• IP address - The IP address of the unit. Specified as four decimal numbers, 0 to 255,
separated by periods
SU-A-EZ Manual
Table 5-8: Ethernet Interface Commands
Ethernet Interface Commands
Mode Page
81
Installer,
Admin
81
Installer,
Admin
82
Installer,
Admin
82
Instaler,
Admin
81