Table of Contents
Advertisement
Chapter 5 - Command Line Interface
Default Setting
10.0.0.1
Command Mode
Installer, Admin
Example
Installer# set ClientSta bridge-static-ip 192.168.1.1
Installer#
5.8.3
set ClientSta default-gw
This command sets the IP address of the gateway router between this device and
management stations that exist on other network segments.
Syntax
set ClientSta default-gw <gateway IP address>
• gateway IP address - The IP address of the gateway router. Specified as four decimal
numbers, 0 to 255, separated by periods
Default Setting
0.0.0.0
Command Mode
Installer, Admin
Example
Installer# set ClientSta default-gw 192.168.0.0
Installer#
5.8.4
set ClientSta dhcpc
This command enables the SU-A-EZ to obtain an IP address from a DHCP server.
DHCP is disabled by default. To set a new IP address you must first either enable
DHCP, or enter it manually using the "set ClientSta bridge-static-ip" command.
Syntax
set ClientSta dhcpc <yes | no>
• yes - Enables DHCP.
• no - Disables DHCP.
Default Setting
Disabled
Command Mode
Installer, Admin
Example
Installer# set ClientSta dhcpc yes
Installer#
82
Operation
Advertisement
Table of Contents
