Figure 2-8: Preparing The Power Cord; Figure 2-9: Preparing The Local Ethernet Cable - Alvarion BreezeACCESS 900 System Manual

Chapter 2 - Installation
To prepare the power cord:
1. Release the domed sealing nut and the special clip of the power cord
protective connector.
2. Push the ½ inch conduit over the power cable and through the
domed sealing nut until it reaches the end of the special clip.
Continue pushing it onto the ferrule, and then tighten the domed
sealing nut.
Preparing the Local Ethernet cable
This section is only for those requiring a local Ethernet connection.
2-12

Figure 2-8: Preparing the Power Cord

Figure 2-9: Preparing the Local Ethernet Cable

BreezeACCESS 900 System Manual rev 1.1