Dirt Container & Filter: Removal & Replacement; Belt Or Brushroll: Removal & Replacement - Dirt Devil M084610 Owner's Manual

DIRT CONTAINER & FILTER: REMOVAL & REPLACEMENT
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE REMOVING OR REPLACING
FILTER.
NOTE: For best performance, replace filter yearly.
Please use reminder label located on filter cap to record replacement date.
FILTER TYPE
For F2 filter replacement, please call 1-800-321-1134 or visit our website at
F2
www.dirtdevil.com to locate a dealer nearest you.
1. 2.
Depress button on top Remove lid by grasping
of dirt container lid to
handle on dirt container lid
remove dirt container.
and turn counter clockwise.
4. 5.
Clean filter and empty dirt Return filter to dirt
container completely. See container. Twist filter
"Regular Maintenance" clockwise to lock into
note below for instructions position.
on cleaning the filter.
8.
Return dirt container
to base of unit.
*REGULAR MAINTENANCE: Each time the dirt container is emptied, the filter should be cleaned. Tap the filter firmly
against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use, this will
not affect the filter's performance.) Do not brush the filter. The cleaning instructions may vary depending on the dirt
conditions. In some cases, more or less cleaning of the filter may be required.
3. 3a.
UNLOCK
Hold the dirt container and grasp the top of the filter.
Twist the filter counter clockwise to unlock (Diagram
3a). Pull the filter up and out.
6.
7.
Return lid to dirt Line up arrow on dirt
container. container with lock/
unlock arrows on dirt
container lid for proper
alignment. Turn clock-
wise to lock lid in
place.
7
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CHANGING BELT OR
BRUSHROLL.
BELT STYLE
For Belt Style 15 replacements, please call 1-800-321-1134 or visit our website at
15
www.dirtdevil.com to locate a dealer nearest you.
TO REMOVE BELT
1.
Lay cleaner flat and flip cleaner to Tilt rollers up and away from
expose nozzle base. Base should lay
the base of the cleaner as you
flat and face up. To remove nozzle
remove the nozzle guard
guard, use Phillips screwdriver to
remove the six (6) screws. Arrows
show location of screws.
TO REPLACE BELT OR BRUSHROLL
4.
5.
Lift and remove brushroll. Dispose Slide belt onto motor shaft.
of old belt.
7.
7a.
With new belt in place, pull and slide Reattach nozzle guard by
brushroll into nozzle making sure that carefully sliding back into
place. Interlock rollers and
the brushroll end caps are in the correct
orientation (7a inset). Rotate brushroll nozzle guard by tilting rollers
manually to make sure belt is properly down towards the base while
replacing the nozzle guard.
aligned.
3.
2.
Slide belt off motor shaft.
6.
Place new belt in area of
brushroll without bristles.
8. 9.
Be sure to replace all six (6)
screws.
8
MOTOR
SHAFT