Crankshaft Position (Ckp) Sensor - Kohler KG2204 Service

5.3. Crankshaft Position (CKP)
Sensor
Figure 5-4 Crankshaft Position Sensor
WARNING
Avoid possible death or serious injury! Pinch and
entanglement hazards!
Never check drive belt tension while the engine is running.
WARNING
Rotating parts can cause severe injury.
Stay away while the engine is in operation.
Keep hands, feet, hair, and clothing away from all moving
parts to prevent injury. Never operate the engine with
covers, shrouds, or guards removed.
Refer to the Engine Service Manual section for detailed
instructions for assembly and disassembly of the
crankshaft position sensor.
90 Installation and Removal Procedures
5.3.1. Removal Procedure
Make sure that the engine is off.
If the engine is used as part of a generator set,
disconnect AC power to the generator set by
opening the upstream circuit breaker.
Disconnect the engine starting battery, negative
(-) lead first.
Shut off the fuel supply.
Remove three electrical harness clamp bolts, flat
washers, and lock washers from crankshaft
position sensor wiring harness.
Remove the mounting bolt, flat washer, and lock
washer from the crankshaft position sensor.
Remove the sensor.
5.3.2. Installation Procedure
Install the crankshaft position sensor to the
mounting bracket.
Use the mounting bolt, flat washer, and lock
washer to secure the crankshaft position sensor.
Use three electrical harness clamp bolts, flat
washers, and lock washers to secure the sensor
wiring harness.
Reconnect the battery.
If the engine is used as part of a generator set,
re-apply the AC power supply to the generator set
by closing the upstream circuit breaker.
Turn on the fuel supply.
Start and run the engine until normal operating
temperature is reached.
Turn off the engine.
Check for any DTCs and troubleshoot. Refer to
Section 2, Diagnostic Troubleshooting Codes
for further diagnosis.
TP-6903 5/16a