Engine Removal/Installation - Honda HRR216VKA K5 Manual

5. ENGINE REMOVAL/INSTALLATION

1. REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . .
1. REMOVAL
1. Disconnect the spark plug cap.
2. Drain the gasoline from the fuel tank into an
approved container.
3. Drain the engine oil (page
4. Release the recoil starter rope from the handlebar
rope guide.
5. Disconnect the flywheel brake cable from the
engine.
6. Remove the blades.
7. Remove the 3/8-24 x 1" flange bolt and remove the
blade holder and Woodruff key.
8. K9 through K11 models: serial numbers
MZCG-9506882~9999999 and MZCG-1000001 ~
1999999:
Remove the belt guide.
9. Slide the drive pulley off the crankshaft and remove
the V-belt.
10. Support the engine, remove the four 5/16-24 x 1"
engine mounting flange bolts, and remove the engine.
5-1
SERVICE BULLETIN #98 =>
3-7).
2. INSTALLATION . . . . . . . . . . . . . . . . . . . . .
K9~K11 BLADES SHOWN
ENGINE MOUNTING
BOLT (4)
UPPER BLADE
WOODRUFF KEY
BLADE HOLDER
LOWER BLADE
SPECIAL
WASHER (2)
BLADE BOLT (2)
3/8-24 x 1" FLANGE BOLT
5-2
BELT
GUIDE
DRIVE PULLEY
5-1