Clip Director/Mower Deck/Wheels - Honda HRR216VKA K5 Manual

12. CLIP DIRECTOR/MOWER DECK/WHEELS

1. CLIP DIRECTOR (K9~K11 ONLY) . . . . .
2. MOWER DECK . . . . . . . . . . . . . . . . . . . .
1. CLIP DIRECTOR (K9~K11 ONLY)
REMOVAL/INSTALLATION
1. Move the Clip Director lever to the BAG position.
2. Turn the fuel valve OFF and tilt the mower on its
right side with the gas filler cap up.
3. Remove the three 6 x 10 mm flange bolts [1], two
6 x 8 mm shoulder bolts [2], and one shoulder
screw [3], and then remove the rear scroll.
4. Remove the 5 x 16 mm self-tapping screw.
5. Remove the two 6 mm cap nuts and special bolts.
6. Lift the Clip Director lever and shutter cover
assembly away from the mower deck.
If you remove the handle from the cover, be
careful. The handle is spring loaded and tends to
pop apart when removed.
7. Remove the Clip Director door through the back of
the deck.
8. Installation is done in the reverse order of removal.
Pay attention to the following:
• Be sure the Clip Director is fully open (BAG
position) when installing the rear scroll.
• Align the lower Clip Director hinge pin with the
hole in the scroll.
• Use a long flat blade screwdriver and a piece of
tape to hold the upper special nut in place while
installing the shoulder screw [3] in the center of
the rear scroll.
• Make sure the Clip Director shutter door pivot
point aligns with the hole in the rear scroll when
assembling.
12-1 3. WHEELS . . . . . . . . . . . . . . . . . . . . . . . . .
12-2
[2]
[2]
Shown with blades
removed for clarity.
5 x 16 mm
SELF-TAPPING
SCREW
6 mm CAP NUTS
12-5
[1]
[3]
[1]
[1]
12-1