Transmission - Honda HRR216VKA K5 Manual

1. TRANSMISSION (K5 AND K6) . . . . . . . .
2. TRANSMISSION (K7) . . . . . . . . . . . . . . .
1. TRANSMISSION (K5 and K6)
REMOVAL
1. Drain the fuel tank and engine oil.
2. Loosen the Smart Drive cable adjuster
3. Cut the cable ties attaching the flywheel brake cable and
the Smart Drive cable to the handle pipe.
4. Set the height adjusting lever in the highest cutting
position.
5. Protect the upper handle pipe and tip the mower up and
secure the upper handle pipe in a bench vise.
6. Remove the belt cover, belt tension spring, and drive belt
(P. 4-2).
7. Rotate the transmission out slightly (not too far or you'll
kink the cable).
8. Use needle nose pliers to remove the snap fitting from
the clutch cable holder, and disconnect the Smart Drive
cable end from the transmission control arm.
9. Remove the wheel bolt, wheel, wheel washer, and flat
washer from each side.

13. TRANSMISSION

13-1 3. TRANSMISSION (K8 ~ K11) . . . . . . . . .
13-7
SNAP
FITTING
(P. 3-10).
SMART
DRIVE
CABLE
END
TRANSMISSION
CONTROL ARM
FLAT WASHER
WHEEL
BOLT
CABLE HOLDER
SLOT
BELT TENSION
SPRING
WHEEL WASHER
INSTALLATION:
Install curved side
as shown:
13-13
WHEEL
13-1