Blade Holder/Drive Belt - Honda HRR216VKA K5 Manual

1. BLADE HOLDER . . . . . . . . . . . . . . . . . . . .
2. DRIVE BELT (K5, K6) . . . . . . . . . . . . . . . .
3. DRIVE BELT (K7). . . . . . . . . . . . . . . . . . . .
1. BLADE HOLDER
REMOVAL/INSTALLATION
1. Turn the fuel valve to the OFF position. This
will reduce the possibility of fuel leakage
when the mower is tilted.
2. Disconnect the spark plug cap.
3. Tilt the mower on its right side so the
carburetor is up.
4. Remove the two blade bolts and special
washers, and then remove the blades
(page 3-5).
5. Remove the 3/8-24 x 1" flange bolt and
remove the blade holder.
6. Install in the reverse order of removal. Pay
attention to the following:
• Note that the keyway for the blade holder
Woodruff key is on the opposite side of the
crankshaft from the slot for the drive pulley
key.
• Use a torque wrench to tighten the blade bolts
and blade holder bolt.
TORQUE:49 ~ 59 N•m (36 ~ 43 ft-lbs)

4. BLADE HOLDER/DRIVE BELT

4-1
4-2
4-4
K9~K11 BLADES SHOWN
UPPER BLADE
LOWER BLADE
SPECIAL
WASHER (2)
3/8-24 X 1"
FLANGE
BOLT
4. DRIVE BELT (K8). . . . . . . . . . . . . . . . . . . .
5. DRIVE BELT (K9/K10/K11) . . . . . . . . . . . .
BLADE HOLDER
BLADE BOLT (2)
4-6
4-7
WOODRUFF KEY
DRIVE PULLEY
4-1