Flywheel/Ignition Coil - Honda HRR216VKA K5 Manual

1. DISASSEMBLY/REASSEMBLY . . . . . . . . .
2. FLYWHEEL REMOVAL/INSTALLATION . .
1. DISASSEMBLY/REASSEMBLY
(K5 thru K8)
1. Remove the recoil starter
2. Remove the fan cover stud, the 6 x 20 mm flange bolt, and the ignition coil.
3. Remove the 14 mm special nut and the flywheel
4. Remove the wire from the brake assembly; then remove the 6 x 23 mm and 6 x 14 mm flange bolts and the brake
assembly.
14 mm SPECIAL NUT
REMOVAL/INSTALLATION:
TORQUE:
52 N•m (38 ft-lb)
FLYWHEEL
REMOVAL: P. 9-3
When disassembling and
reassembling, take care
not to damage the fan
blades.
FAN COVER STUD BOLT (3)
12 N•m (9 ft-lb)
IGNITION COIL
INSPECTION: P. 9-6
ADJUSTMENT: P. 9-6
HIGH-TENSION CORD
REASSEMBLY:
Check for cracked or
damaged insulation;
replace if necessary.
25 x 18 mm SPECIAL
WOODRUFF KEY
REASSEMBLY:
When installing the
flywheel, check to be sure
that the woodruff key
remains in its slot on the
crankshaft.

9. FLYWHEEL/IGNITION COIL

9-1
9-3
(P. 7-1) and fan cover (P.
(page
P. 9-3
6 x 20
FLANGE
BOLT
BREATHER VALVE
BREATHER COVER GASKET
Do not reuse.
3. IGNITION COIL . . . . . . . . . . . . . . . . . . . . .
8-24).
9-3).
6 x 23 FLANGE
BOLT
BRAKE
LEVER
SPRING
CLIP A
4 x 12 mm SCREW WASHER
1.8 N•m (1.3 ft-lb)
4 mm WASHER
ENGINE STOP SWITCH
INSPECTION: P. 2-20
FLYWHEEL BRAKE
INSPECTION: P. 3-12
6 x 14 FLANGE BOLT
STOP SWITCH WIRE
BREATHER
COVER
6 x 14 FLANGE BOLT
12 N•m (9 ft-lb)
9-6
9-1