Bluetooth Connection - KBL megaSun space 2000 Manual

depends on the strength of the external signal and
should be carried out by a service engineer.

Bluetooth connection

To connect an external player (smartphone etc.) wire-
lessly to the solarium an optional Bluetooth interface
is available.
CONNECT EXTERNAL PLAYER
A bluetooth connection can be established in standby
and during tanning mode.
Make sure that you are within the recep-
tion area (about 2 meters).
Make sure that your device is configured
to search for other bluetooth devices.
Should this not be the case, enable blue-
tooth manually. To do so, please read the
instructions for your appliance.
• Depending on your settings the search will be
performed automatically or manually. All available
bluetooth devices within reach will be listed after
a short time.
• Among the available devices choose "megaSun".
In the service menu, a trailing number (01, 02, 03,
...) can be added to device name.
• If necessary confirm the shown code and connect
again. Not every smart phone asks for a code.
megaSun 01
• A two-time beep indicates that your device is con-
nected to the solarium.
megaSun 01
• Set your device to a medium volume level and
start the music.
• Adjust the volume level on your device.
• During the tanning session, the volume control has
to be done at the tanning device.
DISCONNECT EXTERNAL PLAYER
An existing connection is disconnected automati-
cally after tanning.
The connection is automatically disconnected if the
tanning session is not started within 6 minutes.
M a n u a l e o p e r a t i v o | megaSun space 2000
megaSun 01
megaSun 01
11