Sntp Configuration Menu - Panasonic GA-ML Series Manual

3.7.1.

SNTP Configuration Menu

Select P (command) on the Time Configuration menu, and then you can see the
SNTP server Menu as screen 2.7-21. You can configure SNTP servers on this screen.
PNxxxxxx Local Management System
Time Configuration Menu -> SNTP Configuration Menu
SNTP State : Disabled
Interval : 720 seconds
SNTP Server IP
----------------------------------------
192.16.1.2
192.16.2.1
-------------------------------- <COMMAND> -----------------------------------
Set SNTP [S]tate
Set SNTP [I]nterval
Add SNTP Server IPv[4]
Add SNTP Server IPv[6]
[D]elete SNTP Server IPv4
Delete SNTP Server I[P]v6
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
SNTP State Displays the configuration to enable or disable SNTP.
The factory default settings is "Enable".
Interval Displays the interval of time synchronization with SNTP servers.
The factory default settings is 720 seconds.
SNTP Server IP Displays an IP address of SNTP servers that perform a time synchronization.
The maximum number of registrations for IP address: up to two for IPv4 and
IPv6, respectively.
Version Displays SNTP version received.
Last Receive Displays the time when SNTP is received at the end (or in the previous time).
Figure 3-23: SNTP Configuration Menu
Version Last Receive
-------- --------------
4 00:02:02
-------- --------------
59