Replacing Fuse - Yamaha F200 Owner's Manual

EMU29493

Replacing fuse

If the fuse has blown on an electric start mod-
el, open the fuse box and use a fuse puller to
replace the fuse with a spare one of the prop-
er amperage.
EWM00631
WARNING
Substituting an incorrect fuse or a piece of
wire could allow excessive current flow.
This could cause electric system damage
and a fire hazard.
ECM01382
NOTICE
If a main fuse has blown, be sure to also
G
check the other main fuse.
If the outboard motor is operated after a
G
main fuse has blown charging capability
will be insufficient, and the engine will
not start.
Trouble Recovery
1. Fuse box
2. Fuse puller
1. Spare fuse (5 A, 20 A, 30 A)
2. Engine control unit / ignition coil / electric
fuel pump / fuel injector / ISC (idle speed
control) fuse (20 A)
3. Rectifier Regulator (Accessory) fuse (30 A)
4. Main switch / trim switch fuse (20 A)
5. Fuel feed pump fuse (5 A)
6. Rectifier Regulator (Main) fuse (30 A)
7. Starter relay fuse (30 A)
Consult your Yamaha dealer if the new fuse
immediately blows again.
85