Controls; Engine Shut-Off Cord (Lanyard); Engine Oil - Yamaha F200 Owner's Manual

Operation
EMU36460

Controls

Turn the steering wheel full-right and full-
G
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
Operate the throttle levers several times to
G
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
G
the throttle and shift cables under the en-
gine cowling.
EMU36481

Engine shut-off cord (lanyard)

Inspect the engine shut-off cord for damage,
such as cuts, breaks, and wear.
1. Cord
2. Clip
3. Engine shut-off switch
48
1. Cord
2. Clip
3. Engine shut-off switch
EMU37061

Engine oil

1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01790]
2. Remove the top cowling.
3. Remove oil dipstick and wipe it clean.
4. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
5. Check the oil level using the dipstick to be
sure the level falls between the upper lev-
el mark " " and lower level mark " ".
Consult your Yamaha dealer if the oil lev-
el is out of specified level or if it appears
milky or dirty.
ON ON
OFF START OFF START
3
2
1
ZMU04564