Yamaha F200 Owner's Manual page 79

1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01860]
2. Start the engine. Warm it up and keep the
idle speed for 5-10 minutes.
3. Stop the engine and leave it for 5-10 min-
utes.
4. Remove the top cowling.
5. Remove the oil filler cap. Pull out the dip-
stick and use the oil changer to extract
the oil completely.
1
1. Oil changer
6. Add the correct amount of oil through the
filler hole. Put back the filler cap and the
dipstick. NOTICE: Overfilling the oil
could cause leakage or damage. If the
oil level is above the upper level mark,
drain until the level meets the speci-
fied capacity.
[ECM01850]
1. Oil filler cap
Recommended engine oil:
4-stroke outboard motor oil
Amount of adding engine oil (at Periodic
maintenance) Excluding oil filter:
4.5 L (4.76 US qt, 3.96 Imp.qt)
Amount of adding engine oil (at Periodic
maintenance) Including oil filter:
4.7 L (4.97 US qt, 4.14 Imp.qt)
7. Leave the outboard motor for 5-10 min-
utes.
8. Remove oil dipstick and wipe it clean.
9. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
10. Recheck the oil level using the dipstick to
be sure the level falls between the upper
level mark " " and lower level mark " " .
Consult your Yamaha dealer if the oil lev-
el is out of specified level.
ZMU02142
Maintenance
73