Character Entry - Kenwood NEXEDGE NX-200 Instruction Manual

Display
SITE No.
SITE
SQUELCH LEVEL
SQUELCH OFF
STACK
STATUS
SHORT MESSAGE
TALK AROUND
TX AUDIO EQ
TX AGC
TX NOISE SUPPR
PASSWORD
VIBRATOR
VOICE MEMO
VOX LEVEL
VOX
ZONE DEL/ADD

CHARACTER ENTRY

There are 2 methods available for entering characters:
1) Pressing the
Press
and a space (default settings).
You can also assign a character to an optional key and later
press that key to recall the assigned character: A ~ Z, a ~ z,
0 ~ 9, or a space and characters.
2) Using the DTMF keypad
Press the keypad keys to enter characters as shown in the
table below:
DTMF Key Character Cycle DTMF Key Character Cycle
1
2
3
4
5
Display Site Number
Site Select Mode
Squelch Level mode
Squelch Off ON/OFF
Stack mode
Status mode
Short Message mode
Talk Around ON/OFF
TX Audio Equalizer mode
TX Audio Gain Control mode
TX Noise Suppressor mode
Transceiver Password mode
Vibrator ON/OFF
Voice Memo mode
VOX Level mode
VOX ON/OFF
Zone Delete/Add
/ keys
/ to cycle the characters from A ~ Z, 0 ~ 9,
1
A B C 2
D E F 3
G H I 4
J K L 5
Description
6 M N O 6
7 P Q R S 7
8 T U V 8
9 W X Y Z 9
0 [space] 0
17