Basic Operations; Switching Power On/Off; Adjusting The Volume; Selecting A Zone And Channel/Group Id - Kenwood NEXEDGE NX-200 Instruction Manual

SWITCHING POWER ON/OFF

Turn the Power switch/ Volume control clockwise to switch the
transceiver ON.
Turn the Power switch/ Volume control counterclockwise fully
to switch the transceiver OFF.
■ Transceiver Password
(NX-200/300/200G/300G/205G/305G Only)
If the transceiver is password protected, "PASSWORD" will
appear on the display when the power is turned ON. To
unlock the transceiver, enter the password:
1 Select a character using
• On keypad models, you can enter the password directly.
2 Press
• This step is unnecessary when using the keypad.
3 Repeat steps 1 and 2 to enter the entire password.
• Press
# to delete all characters.
4 Press
• If you enter an incorrect password, an error tone sounds
and the transceiver remains locked.
• The password can contain a maximum of 6 digits.

ADJUSTING THE VOLUME

Rotate the Power switch/ Volume control to adjust the volume.
Clockwise increases the volume and counterclockwise
decreases it.

SELECTING A ZONE AND CHANNEL/GROUP ID

Select the desired zone using the key programmed as Zone
Select or Zone Up/Down. Each zone contains a group of
channels.
12

BASIC OPERATIONS

to enter the selected character.
or # to delete a character. Press and hold
or to confirm the entry.
/ .
or