Rinnai EX08CT Installation And Operation Manual page 19

Final Checklist
□
The heater is not subject to corrosive compounds
in the air.
□
Clearances from the heater unit are met.
□
Clearances from the vent termination are met.
□
Ensure you have used the correct venting
products for the model installed and that you have
completely followed the venting manufacturer's
installation instructions and these installation
instructions.
□
Verify that the vent system does not exceed the
maximum length for the number of elbows used.
□
A manual gas control valve has been placed in the
gas line to the heater.
□
Check the gas lines and connections for leaks.
□
Confirm that the gas inlet pressure is within limits.
□
Confirm that the heater is rated for the gas type
supplied.
□
Confirm that the electricity is supplied from a 120
VAC, 60 Hz power source, is in a properly
grounded circuit, and turned on.
□
Verify the system is functioning correctly by
connecting your manometer to the gas pressure
test port on the water heater. Operate all gas
appliances in the home or facility at high fire. The
inlet gas pressure at the heater must not drop
below that listed on the rating plate.
□
Install the front panel.
□
Explain to the customer the importance of not
blocking the vent termination.
□
Explain to the customer the operation of the
heater, safety guidelines, maintenance, and
warranty.
□
The installation must conform with local codes or,
in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, or the
Natural Gas and Propane Installation Code, CSA
B149.1. If installed in a manufactured home, the
installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24
CFR, Part 3280 and/or CAN/SCA Z240 MH
Series, Mobile Homes.
□
Leave the entire manual with the consumer.
Rinnai Corporation EX08CT, EX11CT Manual 19