Table Of Times; Operating Status Indication - Riello RG1RKD Installation, Use And Maintenance Instructions

6.7

Table of times

Symbol Description
t0 Standby: the burner is waiting for a heat request
t1 Standby time for an input signal: reaction time, control box remains in waiting mode for t1
t1l Flame or flame simulation detected before demand for heat: the control box remains idle.
t2 Initialisation standby time: checking time following the main power start-up
Checks extraneous light or parasite flame during t2: waiting mode for t2l, then lockout: the motor
t2l
does not start
t2p Oil pre-heating time: waiting mode for t2p, then there is a lockout (if there is a heater)
t3 Pre-purging time: The fan motor is running, then the gas valve is activated
Checks extraneous light or parasite flame during pre-purging: control box goes into lockout at the
t3l
end of t3l
t3i Spark pre-ignition time
ts Safety time
t4i Total spark ignition time
t4l Reaction time to achieve safety deactivation due to flame loss
Delay time between the 1st and 2nd stage: opening time of 2nd stage valve after opening of the
t5
1st stage
t5i Spark post-ignition time
- Minimum time to reset the control box using reset button
Minimum time to reset the control box using remote reset
Re-cycles: Max. no. 3 repeats of the complete start-up sequence in the case of flame loss during
tr
operation; the final action at the last attempt following flame failure is a lockout
6.7.1

Operating status indication

Status
Awaiting heat request
Awaiting heat request with continuous purging
Pre-heating time
Pre-purging, or long pre-purging
Safety time without flame
Safety time with flame
Normal operating position
Key
ON
20138077
Start-up, calibration and operation of the burner
OFF Colour code
RED
ORANGE
GREEN
Reset button
colour
-
ORANGE
Blink
GREEN
Blink
ORANGE
Blink
GREEN
Blink
GREEN
GREEN
Tab. J
26 GB
Value (sec.)
max 600
re-cycles
Seconds Colour code
- - -
0.5 2.5
0.5 2.5
0.5 0.5
0.5 0.5
- -
- -
-
2
25
4.5
25
15
25
5
5
15
1
20
3
0.4
0.8
3
Tab. H
Tab. I