Mitsubishi Electric SUZ-KA24NAHZ Service Manual page 96

OPERATING PROCEDURE
5. Removing the thermistor <Discharge> (TH4)
(1) Remove the service panel. (See Photo 1)
(2) Disconnect the connector TH4 (white) on the controller cir-
cuit board in the electrical parts box.
Loosen fasteners for lead wires in the electrical parts box.
(3) Loosen clamps for the lead wire on the separator (See
Photo 7).
(4) Pull out the thermistor <Discharge> (TH4) from the sensor
holder.
6. Removing the thermistor <Liquid> (TH3), thermistor
<Suction> (TH32), thermistor <Comp. surface> (TH33)
(1) Remove the service panel. (See Photo 1)
(2) Disconnect the connectors, TH3 (white) and TH32 (black), TH33
(red) on the controller circuit board in the electrical parts box.
Loosen fasteners for lead wires in the electrical parts box.
(3) Loosen clamps for the lead wires on the separator (See Photo 7).
Loosen clamp and cable strap for lead wires on the bottom
of the electrical parts box. (Note that this procedure is only
for removing TH32.)
(4) Loosen clamp for the lead wire for TH3 and TH32.
(5) Pull out the thermistor <Liquid> (TH3), thermistor <Suction>
(TH32), thermistor <Comp. surface> (TH33).
OCH754A
PHOTOS/FIGURES
Photo 7
Separator
Clamp
Compressor
(MC)
Thermistor
<Discharge>
(TH4)
Photo 8
Thermistor
Clamp
<Comp. surface>
(for TH3, TH32)
(TH33)
96
Muffler
Thermistor
<Liquid> (TH3)
Compressor
Thermistor
<Suction>
(TH32)