Installing Scsi Hard-Disk Drives In The Internal Drive Bays; Scsi Hard-Disk Drive Configuration; Figure 6-1. Internal Drive Hardware - Dell PowerEdge 4200 Series User Manual

Figure 6-1. Internal Drive Hardware

I
nstalling SCSI Hard-Disk Drives
in the Internal Drive Bays
SCSI hard-disk drives are supplied by Dell in special
drive carriers that fit into the internal drive bays (see Fig-
ure 6-2). The circuit board at the back of the drive carrier
acts as an interface between the SCSI hard-disk drive and
the SCSI backplane board.
NOTE: Dell recommends that you use only drives that
Dell has tested and approved for use with the SCSI back-
plane board.
6-2 Dell PowerEdge 4200 Systems User's Guide
SCSI hard-disk drive bays (6)
SCSI backplane board
Ultra/Wide SCSI interface cable
Ultra/Wide SCSI host adapter
connector (SCSI)
system board

SCSI Hard-Disk Drive Configuration

The SCSI backplane board provides termination for the
SCSI bus. None of the drives connected to the SCSI
backplane board should have their termination enabled.
All SCSI ID numbers for the drives are set by the SCSI
backplane board.