Understanding The Control Panel; Leds; Stop Button - Dell 1230c User Manual

UNDERSTANDING THE CONTROL PANEL

The color of the status and toner colors LED indicates the printer's current status.

LEDs

STATUS
lights green all LEDs off
slowly blinks green all LEDs off
fast blinks green all LEDs off
lights red all LEDs off
lights orange all LEDs off
lights green each LED blinks red
blinks red each LED lights red
lights red each LED lights red
lights green each LED blinks red in a
repeated order

Stop button

Printing demo page
Printing configuration sheets
Canceling print job
12 | Introduction
TONER COLORS LED
The printer is ready to print.
The printer is receiving data from the computer.
The printer is printing data.
• The printer is experiencing an error, such as open cover, empty paper, not installed waste toner
container, or full waste toner container.
• The printer is experiencing a service required error, such as LSU error, fuser error, or ITB error,
Contact your sales or service representative.
• The printer is experiencing an error such as jammed paper.
• While the printer is booting up, do not open a top cover, since the printer may treat it as an error
such as paper jam. In this case, open a front cover and close it then, the printer will reboot up.
Each toner cartridge is near the end of its life.
Each toner cartridge is almost empty. You can print, but the quality is not reliable.
• Each toner cartridge is totally exhausted. You cannot print anymore.
• Each toner cartridge is wrong.
The printer is warming up.
In Ready mode, press and hold this button for about 2 seconds until the status LED blinks slowly, and release.
In Ready mode, press and hold this button for about 5 seconds until the status LED blinks fast, and release.
Press this button during printing. The red LED blinks while the print job is cleared from both the printer and the computer,
and then the printer returns to Ready mode. This may take some time depending on the size of the print job.
DESCRIPTION
DESCRIPTION