Hunter Lantern Bay 59581 Installation Manual page 9

Follow these steps to prepare the light fixture for installation.
Remove the pre-installed fixture screw and red
flag from the light kit assembly. Save the screw.
It will be needed for light kit installation.
Note: The screw was installed for shipping purposes only.
Ceiling Bracket Downrod
Preparing the Light Fixture
KEEP
x1
Fixture Screw
Red Flag
Installing the Light Fixture Hood
Partially install two fixture mounting
screws ,found in the hardware
bag, into the motor housing as
shown. It does not matter which two
screw holes you choose.
Hanging Fan Wiring
2 of 3
Fixture Mounting Screw
bag
Insert the third screw, found in the
bag, into place and then tighten all three screws.
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all 3 assembly screws could result in the
switch housing fixture falling.
Canopy Blades
Carefully remove the light
fixture from the light fixture
hood and set the light fixture.
Feed the wire plug through the center hole of
the light fixture hood. Align the keyhole slots
in the hood with the two screws you just
installed. Lift the hood so that the keyhole
slots engage the two screws, and twist
counterclockwise to lock the hood into place.
1 of 3
Fixture Mounting Screw
bag
hardware
IMPORTANT
Light Bulbs/Cage Remote Cradle
1886
8