Dell OptiPlex GX1 Reference And Installation Manual page 149

WARNING: Could not con-
figure Plug and Play Card
Name .
WARNING: Could not con-
figure PCI device,
ID= DeviceID .
Failed to configure Num-
ber of Total Count Plug
and Play ISA devices. Use
your system's configura-
tion utility to resolve
conflicts. Press any key
to continue.
WARNING: Boot Device
conflict detected!
CSN= Card Select Number
Error= Error .
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
The card(s) mentioned
are not fully configured
due to resource conflicts.
One of the devices is
attempting to use one or
more resources assigned
to the system's boot
device.
If you do not know the allowable resource
values for your Plug and Play or PCI expan-
sion card, use the following procedure to
locate and resolve the resource conflict:
See "Removing a Card" in Chapter 3
for instructions.
The ICU should automatically config-
ure your Plug and Play or PCI
expansion card.
See "Adding a Listed Card" in
Chapter 3 for instructions.
If your Plug and Play or PCI expansion card
is not automatically configured when you
reboot the system with all other cards
removed, you should contact the manufac-
turer of the card or see Chapter 7 , "Getting
Help," in your Diagnostics and Troubleshoot-
ing Guide .
Perform the following procedure:
err
This card is attempting to use one or
more resources required by the sys-
tem's boot device.
ISA Configuration Utility Messages
config
B-9