Dell OptiPlex GX1 Reference And Installation Manual page 142

Out of memory
Memory allocation
failed
Not enough memory
to run the ICU
Can't open index
file. This file is
required for ICU to
run.
No Configuration
Manager.
At least one Plug
and Play card in
your system is not
configured due to
conflicts. These
are marked "config
err" in the list of
configured cards.
Due to conflicts,
the ICU could only
configure some Plug
and Play cards in
your system. Un-
configured cards
are marked "config
err" in the list of
configured cards.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
B-2 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide
Either of these messages
can appear if the system
runs out of memory dur-
ing operation of the
utility.
This message appears
when you start the ICU if
the system does not
have enough memory to
run the utility.
The ICU cannot find the
index file for its database.
The device driver needed
by the ICU is corrupted or
is not correctly
configured.
The Configuration Man-
ager or the ICU cannot
configure at least one
Plug and Play expansion
card because of resource
conflicts with one or
more cards.
Disable any TSR programs or any unneeded device
drivers.
Make sure to switch to drive A before attempting
to start the utility.
Verify that the following device statement appears
in your config.sys file:
device= drive :\ directory \driv-
ers\dos\dwcfgmg.sys
In this statement, drive and directory repre-
sent the drive and directory where the driver
resides. The default is c:\plugplay.
You must reconfigure the conflicting card(s). To
find the conflicting card, perform the following
steps:
config err
The Card Configuration dialog box displays the
functions assigned to the Plug and Play expan-
sion card.