Remote Control Button - Panasonic CS-RZ25TKR Service Manual

4 REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 16 seconds (4 "beep" sounds will occur at 16th seconds to identify the Remote
Control Receiving Sound Off/On Mode is in standby condition) and press "AC Reset" button at remote
control.
Press "Auto OFF/ON button" to toggle remote control receiving sound.
Short "beep": Turn OFF remote control receiving sound.
o
Long "beep": Turn ON remote control receiving sound.
o
After Auto OFF/ON Button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON
Mode is restarted.

16.2 Remote Control Button

16.2.1 SET BUTTON

To check remote control transmission code and store the transmission code to EEPROM
Press "SET" button by using pointer.
o
Press "TIMER SET" button until a "beep" sound is heard as confirmation of transmission code changed.
o

To limit set temperature range for iAUTO-X, COOL & DRY, HEAT mode.
Press "Set" button by using pointer.
o
Press TEMP increment or decrement button to choose No. 3.
o
Press Timer increment or decrement button to select desired temperature low limit of set temperature for
o
iAUTO-X, COOL & DRY mode.
Press Timer Set button to confirm low limit selection.
o
Press TEMP increment or decrement button to choose No. 4.
o
Press Timer decrement or increment button to select desired temperature high limit of set temperature for
o
iAUTO-X, COOL & DRY mode.
Press Timer Set button to confirm high limit selection.
o
Press TEMP increment or decrement button to choose No. 5.
o
Press Timer increment or decrement button to select desired temperature low limit of set temperature for
o
HEAT mode.
Press Timer Set button to confirm low limit selection.
o
Press TEMP increment or decrement button to choose No. 6.
o
Press Timer decrement or increment button to select desired temperature high limit of set temperature for
o
HEAT mode.
Press Timer Set button to confirm high limit selection.
o
LCD returns to original display if remote control does not operate for 30 seconds or press Timer Cancel
o
button.
16.2.2 RESET (RC)

To clear and restore the remote control setting to factory default.
Press once to clear the memory
o
16.2.3 RESET (AC)

To restore the unit's setting to factory default
Press once to restore the unit's setting.
o
16.2.4 TIMER ▲

To change indoor unit indicator's LED intensity
Press continuously for 5 seconds.
o
16.2.5 TIMER ▼

To change remote control display from Degree Celsius (°C) to Degree Fahrenheit (°F)
Press continuously for 10 seconds.
o
108