12.4.5
Connecting the Remote Controller Cable to Indoor Unit
Be sure to turn off the main power before installing and connecting the remote controller.
Otherwise, it will cause the electrical shock.
1
Open front grille complete
(Please refer HOW TO TAKE OUT FRONT
GRILLE).
2
Open the control board cover complete and
terminal board cover complete.
3
Connect remote controller cable 2 to remote
controller 1 and guide the remote controller
cable 2 into the unit through the wire insertion
hole.
4
Guide the remote controller cable 2 into the
remote controller cable holder 5 and tighten
with screws 6. Fasten the remote controller
cable holder to control board with screw 7.
6
Insert firmly the connector of remote controller cable 2 to indoor PCB connector (CN-RMT) and tighten green
wire from remote controller cable 2 with screw 8 to the grounding location provided.
7
After complete, install back removed parts follow reverse procedure.
Note: Remote controller cable cannot be extended.
Control board cover
complete
Terminal board
cover complete
Screw 6
Remote controller cable 2
CAUTION
5
Install back terminal board cover complete. Be
careful not to clamp the cable between
terminal board cover and control board.
Front grille complete
Terminal board
cover complete
Screw 8
Remote controller cable 2
Remote controller
cable holder 5
Screw 7
72
Connector
(CN-RMT)
Green wire
Remote controller 1