Belt And Running Deck; Lubrication (Fig. F-4); Cleaning And Maintenance - Tunturi Cardio Fit T40 User Manual

The warranty does not cover sounds or noises
emitted during use where these do not
substantially impede the use of the equipment
and where they are not caused by a fault in the
equipment.
The warranty does not cover defects arising
from the failure to carry periodic maintenance
as outlined within the Owner's Manual for the
product. Furthermore, the warranty does not
cover defects arising from usage and storage
within an unsuitable environment as described
within the Owner's Manual which should be
indoors, dry, dust and grit free and within a
temperature range of +15°C to +35°C. The
warranty does not cover maintenance activities,
such as cleaning, lubricating, and normal part
adjustments, nor installation
Procedures that customers can accomplish
themselves, such as changing uncomplicated
meters, pedals and other similar parts not
requiring any dismantling/reassembling of the
fitness equipment. Warranty repairs carried out by
other than authorised Tunturi representatives are
not covered.
Failure to follow the instructions given in the
Owner's Manual will invalidate the product's
warranty.

Cleaning and maintenance

WARNING
• Before cleaning and maintenance, remove
the mains plug from the wall socket.
• Do not use solvents to clean the equipment.
- Do not block the ventilation openings. Keep
the ventilation openings clear from dust, dirt
and other obstructions.
- Clean the equipment with a soft, absorbent
cloth after each use.
- Clean the visible parts of the equipment with a
vacuum cleaner with a small suction nozzle
- Regularly check that all screws and nuts are
tight.

Belt and Running Deck

Your treadmill uses a very high-efficient low-
friction bed. Performance is maximized when the
running deck is kept as clean as possible. Use a
soft, damp cloth or paper towel to wipe the edge
of the belt and the area between the belt edge
and frame. Also reach as far as practical directly
under the belt edge. This should be done once a
month to extend belt and running deck life. Use
water only - no cleaners or abrasives. A mild soap
and water solution along with a nylon scrub brush
will clean the top of the textured belt. Allow the
belt to dry before using.

Lubrication (fig. F-4)

The running belt must be checked for lubrication
once per 2 months, based on the average use of
60 minutes per day.
WARNING
• Before lubrication, remove the mains plug
from the wall socket.
CAUTION
• Only lubricate the running belt if necessary.
If you apply too much lubricant, the running
belt will slip easily due to lack of friction.
- Stand steadily on the running belt.
- Take hold of the front handlebar and push the
running belt with your feet so that it slides
back and forth. The running belt must move
smoothly and evenly without making sound.
- If the running belt does not move smoothly and
evenly or if the running belt does not move at
all, touch the underside of the running belt with
your fingertips to check the lubrication:
• If you feel lubrication or your fingertips are
shiny, there is sufficient lubrication on the
running belt.
• If you do not feel lubrication or your
fingertips are dusty or rough, apply lubricant
(15-20 ml) in the middle of the running
deck under the running belt and let the
equipment operate at 5km/h for at least 5
minutes.
• After lubrication, do not fold the equipment
before having done a workout for 20
minutes with a speed of at least 5 km/h.
The lubricant will be spread evenly over the
running belt.
English
21