Adjusting The Running Belt Tension - Tunturi Go RUN 30 User Manual

EN
– If you feel lubrication or your fingertips are shiny, there is sufficient
lubrication on the running belt.
– If you do not feel lubrication or your fingertips are dusty or rough, apply
lubricant (15-20 ml) in the middle of the running deck under the running belt
and let the equipment operate at 5km/h for at least 5 minutes.
– After lubrication, do not fold the equipment before having done a workout for
20 minutes with a speed of at least 5 km/h. The lubricant will be spread
evenly over the running belt.
A A ligning the running belt (fig. I)
The running belt must run in the center of the rollers. If the running belt is pushed to
one side, the running belt must be aligned using the adjustment bolts at the rear of
the equipment.
CAUTION
– Make sure that the running belt is aligned correctly to prevent
1. Set the mains power switch to the on position.
2. Set the speed to 5 km/h.
3. If the running belt runs in the center of the rollers, the running belt is aligned
correctly.
4. If the running belt drifts to the left, turn the left adjustment bolt 1/4 turn clockwise
and the right adjustment bolt 1/4 turn counterclockwise.
5. If the running belt drifts to the right, turn the right adjustment bolt 1/4 turn
clockwise and the left adjustment bolt 1/4 turn counterclockwise.
6. Repeat the last 2 steps until the running belt is aligned to the centre.

Adjusting the running belt tension

The running belt tension must be adjusted when it starts to slip on the rollers. The
running belt tension must be adjusted using the adjustment bolts at the rear of the
equipment.
26
damage to the edges of the running belt.
RUN 30