Front Axle - Husqvarna LB 548 i Workshop Manual

7.6.2 To remove and attach the rear wheels
1. Use a flat screwdriver to remove the hub cap on the
2 sides of the product.
2. Use a long nose pliers to remove the snap ring on
the 2 sides of the product. Remove the 2 rear
wheels.
Note: If it is necessary, remove the 2 ball bearings in
the wheel.
3. Attach the wheels in the opposite sequence.
1410 - 001 -

7.7 Front axle

7.7.1 To disassemble and assemble the front axle
1. Remove the front wheels, refer to
attach the front wheels on page 20 .
2. Remove the washers and the spring on the 2 sides
of the product.
3. Remove the snap ring and pull off the rod.
To remove and
Repair instructions - 21