Table of Contents
Advertisement
5.
Fit the washer and circlip on the
pendulum shaft (1).
6.
Connect the hydraulic hose to the
hydrostatic transmission.
7.
Check that the controls and cables are
properly adjusted, see, "Adjusting the
Hydrostatic Transmission Cable" on
page 41.
8.
Check the neutral position contact and
adjust if necessary. See "Micro Switch
Pedal Arrangement" on page 103.
9.
Bleed the hydraulic system of excess air.
Top up the oil as needed after test
running.
10. Fit the transmission cover.
Drive Axles
Remember cleanliness, follow the
instructions under "Hydraulic
system\Hydraulic Hygiene".
Counterhold using a spanner when releasing
and tightening the coupling nuts so that the
hoses or angled nipples are not exposed to
twisting strain.
Front Axle R 422 Ts AWD
The equipment frame must not be
dismantled.
Removal
1.
Remove the cutting unit, see "Removing
the Cutting Unit" on page 75.
2.
Jack up and block the machine.
3.
Remove the front wheels.
46
English-
REPAIR INSTRUCTIONS
Jacking up left
Jacking up right
Advertisement
Table of Contents
