Advertisement
6
The message counter on the
base unit will flash between
0 and C until the day and time
are set.
The day and time must be
set using the BT Freelance XA
3000 handset.
Your BT Freelance XA 3000
automatically adds the day
and time to all messages and
memos received.
When you first switch the
power on, the clock is set to
Sunday, 12.01pm. You can
change the day and time as
required.
Press the
the BT Freelance 3000 handset.
TAM MENU will flash on the
display.
The main menu announcements
are automatically announced
through the handset earpiece when
the
button is pressed twice.
Press the
will announce, "To set day and
time press
time press
(Please note that if you press
the
button this will only allow
you to check the day and time.)
15
button twice on
button. The prompt
, to hear day and
".
Press the
will announce, "Please enter
new day and time after the tone".
After the tone enter the day,
followed by the time using the
24 hour clock.
For example:
= Sunday 2.15pm.
Or
= Thursday 9.15am.
You will then hear your setting
confirmed.
Press the
return the handset to standby.
If the day and time is entered
incorrectly, the prompt will announce,
"Incorrect, please set again". Enter
the correct setting within 15 seconds
otherwise the handset will return to
standby mode. If the day and time
is entered incorrectly three times the
handset will return to standby.
If you have any difficulties setting up
your BT Freelance XA 3000 please
call the Helpline on
button. The prompt
button twice to
.
Advertisement
