Dell G7 15 7500 Service Manual page 74

Table 9. System setup options—Power menu (continued)
Power
Thermal Management
USB Wake Support
Wake on Dell USB-C Dock
Block Sleep
Lid Switch
Enable Lid Switch
Power On Lid Open
Intel Speed Shift Technology
Table 10. System setup options—Security menu
Security
TPM 2.0 Security On
PPI Bypass for Enable Commands
PPI Bypass for Disable Commands
PPI Bypass for Clear Commands
Attestation Enable
Key Storage Enable
SHA-256
74 System setup
Sets cooling fan and processor heat management to adjust system performance,
noise, and temperature.
By default, Optimized is selected.
Enables connecting a Dell USB-C Dock to wake the computer from Standby.
Default: ON
Blocks the computer from entering Sleep (S3) mode in the operating system.
Default: OFF
NOTE: If enabled, the computer will not go to sleep, Intel Rapid Start will
be disabled automatically, and the operating system power option will be
blank if it was set to Sleep.
Enables or disables the lid switch.
Default: ON
Enables the computer to power up from the off state whenever the lid is opened.
Default: ON
Enables or disables the Intel Speed Shift Technology support. Setting this option to
enable allows the operating system to select the appropriate processor performance
automatically.
Default: ON
Select whether or not the Trusted Platform Model (TPM) is visible to the OS.
Default: ON
Enables or disables the OS to skip BIOS Physical Presence Interface (PPI) user
prompts when issuing TPM PPI enabled and activate commands.
Default: OFF
Enables or disables The OS to skip BIOS PPI user prompts when issuing TPM PPI
Disable and Deactivate commands.
Default: OFF
Enables or disables the operating system to skip BIOS Physical Presence Interface
(PPI) user prompts when issuing the Clear command.
Default: OFF
Enables to control whether the TPM Endorsement Hierarchy is available to the OS.
Disabling this setting restricts the ability to use the TPM for signature operations.
Default: ON
Enables to control whether the TPM Endorsement Hierarchy is available to the OS.
Disabling this setting restricts the ability to use the TPM for storing owner data.
Default: ON
Enables or disables the BIOS and the TPM to use the SHA-256 hash algorithm to
extend measurements into the TPM PCRs during BIOS boot.