Steps
1. Align the screw holes on the optional finger-print reader with the screw holes on the palm-rest and keyboard assembly.
2. Replace the screw (M2x2.5) that secures the optional fingerprint reader to the palm-rest and keyboard assembly.
NOTE:
Apply sufficient torque when tightening the screw (M2x2.5) to avoid damaging the screw thread.
3. Align the screw hole on the power button with optional fingerprint reader with the screw hole on the palm-rest and keyboard
assembly.
4. Replace the two screws (M2x2.5) that secure the power button with optional fingerprint reader to the palm-rest and keyboard
assembly.
5. Connect the power button with optional fingerprint reader cable to the connector on the I/O board and close the latch to secure the
cable.
Next steps
1. Install the
system
board.
2. Install the
graphics-card
3. Install the
rear-cover
bracket.
4. Install the
rear
cover.
5. Install the
base
cover.
6. Follow the procedure in
44
Removing and installing components
fan.
After working inside your
computer.