Preparing The Remote - Hunter Parkview 50999 Installation Manual

1886
Battery
Door
ON
ON
Once the power
1
is turned on, the the
remote must be remote must be
paired within 60 paired within 60
seconds. Pairing seconds
Battery
is only required
once after initial
Remove battery door. Change the
installation.
dip switch settings if they match a
previously installed remote transmitter.
Install A23 or MN21 alkaline battery
in the proper polarity and replace the
battery door. To pair the remote, hold
down the Set button for 5 seconds.
Pairing is complete when LED button
flashes twice.
LED
Off
(Low)
9
Ceiling Bracket Downrod

Preparing the Remote

ECE
2 3 4
Set
ON ECE
SET
1 2 3 4
Fan
Speed
Dial
(High)
To select fan speed press
one of the numbers on
the Fan Speed Dial. To
calibrate the fan speed,
run the fan on "6" for 90
seconds after each AC
power reset. The LED light
flashes to indicate a signal
has been sent to the fan.
Installing the Remote Control Cradle
2 of 2
Cradle Screw
To install the
transmitter cradle,
hand-tighten the
provided screws to
mount the cradle
to the wall.
Hanging Fan Wiring
ON ECE
SET
1 2 3 4
(If a light kit is installed)
If a light kit is installed on your fan,
choose the light bulb mode by moving
the toggle switch. Move the switch
towards the "D" for CFL bulbs and
toward "ON" for standard bulbs.
Replace the battery door.
Reverse
Light
(If light kit is
installed)
Canopy Blades
ON ECE
SET
1 2 3 4
_
+
To change the battery, remove the
battery door. Remove battery and
replace with A23 or MN21 alkaline
battery. Please observe proper
polarity placement.
To reverse the air flow direction,
press the Reverse button while
fan is running. Press Light button
to turn lights off/on. To dim the
lights, press the light button for
more than one second. Light will
cycle from brightest to dimmest.
Release the light button when
desired brightness is achieved.
Light Remote Troubleshooting