Table of Contents
Advertisement
OTime-setting options
S etting the clock
T i m e - s e t t i n g o p t i o n s
Once the appliance has been connected to the mains
or after a power cut, "12:00" will flash in the display. The
current time must be set in order for the oven to be
switched on.
Press the "+" and "-" buttons at the same time. The
1.
settings can be configured once the
flashing in the display.
Use the "+" and "-" buttons to set the current time.
2.
If the buttons are not pressed for a long time, the
symbols will stop flashing and the display will show the
set time.
This clock acts solely as a timer. An alert will
Note:
sound once the set time has elapsed – the oven will not
be switched off.
Button lock
The digital timer has an automatic button lock. If the
timer is inactive for at least 10 seconds, the button lock
is activated automatically. The
on the display while the button lock is active.To disable
the button lock, press and hold the "+" and "-" buttons at
the same time for 2 seconds.
Setting the timer
The timer has no effect on how the oven works. The
timer can be set between 1 minute and 23 hours and
59 minutes.
Press and hold the "+" and "-" buttons at the same
1.
time for 2 seconds to disable the button lock.
Press the "+" button. The
2.
display.
Use the "+" and "-" buttons to set the required time. If
3.
the buttons are not pressed for a long time, the
symbols will stop flashing and the display will show
the current time.
An audible signal will sound once the time has
4.
elapsed.
Switching off the audible signal
Press the "+" or "-" button to switch off the timer.
While the timer is active, the display will show the
Note:
current time.
Changing the audible signal
Pressing and holding the "-" button for 5 seconds while
the timer is showing the current time will make the clock
issue a warning signal. The clock has three different
audible signals. A different signal will sound each time
the "-" button is pressed. The last signal you selected is
saved as the default tone.
symbol starts
Ú
symbol will be shown
ó
symbol will flash in the
V
DCleaning
W ith good care and cleaning, your appliance will retain
C l e a n i n g
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
Cleaning agents
Damage to the various different surfaces caused by
using the wrong cleaning agent can be avoided by
observing the following instructions.
When cleaning the hob do not use
undiluted washing-up liquid or dishwasher detergent,
■
scouring pads,
■
abrasive cleaning agents such as oven cleaner or
■
stain remover,
high-pressure cleaners or steam jets.
■
Do not clean individual parts in the dishwasher.
■
When cleaning the oven do not use
sharp or abrasive cleaning agents,
■
cleaning agent with a high alcohol content,
■
scouring pads,
■
high-pressure cleaners or steam jets.
■
Do not clean individual parts in the dishwasher.
■
Wash new sponges thoroughly before first use.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
Zone
Cleaning agent
Stainless steel sur-
Hot soapy water:
faces*
Clean with a dish cloth and dry with a soft
cloth. On stainless steel surfaces, always wipe
(depending on appli-
parallel to the natural grain. Otherwise, you
ance model)
may scratch the surface. Remove patches and
splashes of limescale, grease, starch and albu-
min (e.g. egg white) immediately. Corrosion
can form under such patches and splashes.
Special care products suitable for hot stainless
steel surfaces are available from our after-
sales service and from specialist retailers.
Apply a thin layer of care product with a soft
cloth.
Enamel, painted, plas-
Hot soapy water:
tic and screen-printed
Clean with a dish cloth and dry with a soft
surfaces*
cloth. Do not use glass cleaner or glass scrap-
ers for cleaning.
(depending on appli-
ance model)
* Optional (available for some appliances, depending on the appliance
model)
Time-setting options
en
17
Advertisement
Table of Contents
