Barcode Verifier - SATO CL4NX Plus Driver Manual

Hide thumbs Also See for CL4NX Plus:

Table of Contents

4.4

Barcode Verifier

When the optional barcode checker is installed to the product, the barcode checker scans the

barcodes immediately after printing and checks the accuracy of printed 1D barcode and 2D code.

Settings

[Mode]

Set the Barcode Verifier mode of operation.

Select [Disable] to disable the Barcode Verifier. Select [Readable] to check for readability of

barcodes. And select [Comparison] to check if the scanned results of the printed barcodes

match the barcode print data.

[Set no. of barcodes]

Specify how to set the maximum number of verified barcodes.

Select [Command] to set the maximum number using direct command to the barcode

checker. Select [Setting] to set the maximum number using printer driver interface.

[Barcodes per label]

Set the maximum number of verified barcodes per single printed label. The number is

limited to 10.

[Start position]

Adjust the position at which the barcode checker starts to scan. It starts reading each media

after the specified length passes from the printing start position. This setting can be used to

exclude first barcode(s) from the check target when multiple barcodes are printed on each

media.

[VOID print]

This check box enables printing of error marks on the media if a barcode reading error or

barcode comparison error occurs.

[Retry count]

Set how many times the product will try to print and check the same barcode after VOID

printing if a barcode reading error or barcode comparison error occurs.

Table of Contents