Operation - Husqvarna LG 400 Operator's Manual

Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Use personal protective equipment. Refer to
Personal protective equipment on page 8 .
• Stop the engine and make sure that all parts of the
product are cool before you do the maintenance.
• Clean the product to remove dangerous material
before you do the maintenance.
• Disconnect the spark plug cap before you do the
maintenance.
• The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 13 .
To set the handle to operation position
WARNING: Hold the handle tightly when you
change the position of the handle. There is a
risk of injury if the handle falls on you.
1. Hold the handle.
10
•
•
•
•
•
•
•

Operation

2. Release the lock lever and lower the handle
Maintenance
To start and stop the product
Do not change the product. Modifications that are
not approved by the manufacturer, can cause
serious injury or death.
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
Replace damaged, worn or broken parts.
Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
Let an approved service center do servicing on the
product regularly.
carefully.
WARNING: Keep your feet away from the
product during the start procedure. The
hydraulic system can cause the product to
move suddenly when the engine starts.
1224 - 002 - 06.04.2020