Husqvarna LG 400 Operator's Manual page 16

To do a check of the safety straps
1. Examine the safety straps at the front and the rear of
the product.
2. Examine the screws and nuts on the safety straps.
3. Replace damaged safety straps.
4. Replace damaged nuts and screws.
5. Tighten loose screws and nuts.
To do a check of the engine oil level
1. Remove the oil tank cap and dipstick.
2. Clean the oil from the dipstick.
3. Put the dipstick back fully into the oil tank.
4. Remove the dipstick.
5. Examine the oil level on the dipstick.
6. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 22 or the engine manual for the correct
type of oil.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Engine oil is very hot directly
after the engine stops. Let the engine
become cool before you drain the engine oil.
If you spill engine oil on your skin, clean with
soap and water.
1. Loosen the screw (A) to remove the oil drain hose
from the holder.
16
Technical data
2. Put a container below the oil drain hose.
3. Remove the oil drain plug (B) from the end of the oil
4. Tilt the product and let the engine oil run out into the
5. Install the oil drain plug and tighten it.
6. Put the oil drain hose in the holder and tighten the
a) (LG 400, Honda):
b) (LG 400, Lombardini):
drain hose.
container.
screw (A).
A
B
A
B
1224 - 002 - 06.04.2020