Operation; Specifications; Air Inlet; Warranty - Napa Carlyle Tools 6-711A Instruction Manual

OPERATION

Always turn off the air supply, drain
hose of air pressure and detach tool
from air supply before installing,
removing or adjusting any part or
accessory on this tool, or before per-
forming any maintenance on this tool.
Punch Replacement:
Disconnect air supply
1. Loosen (#30) Die Set
2. Remove (#29) Punch Set.
3. Replace new Punch Set.

WARRANTY

Important: DO NOT RETURN DEFECTIVE PRODUCT OUTSIDE OF ORIGINAL ONE (1) YEAR WARRANTY PERIOD TO
PLACE OF PURCHASE.
WARRANTY POLICY:
from the date of original purchase. We will replace, at our option, any part which proves to be defective in material or workman-
ship. Repairs or replacements are warranted as described above for the duration of the original warranty period. In the unlikely
event a replacement unit is required during this One (1) year period, return the unit to your local NAPA Auto Parts Store for a
replacement. This warranty does not apply to products which have been subjected to abuse, misuse, modification, neglect, lack of
maintenance, use in a production-related service, or repaired by anyone other than an Authorized Carlyle Air Tool Service Center.
For complete listing of Authorized Master Repair Centers, see enclosed Customer Warranty Repair Form, or
visit www.toolwarrantyrepair.com
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MAN U AL FOR FUTURE REF ER ENCE.
6-711A
4. Tighten (#30) Die Set into (#28) Head
housing, check the Die Set is
completely tightened before operating
tool.
NOTE: During operation, safety gog-
gles should always be worn to guard
against flying debris (users and
bystanders).
from tool.
This Carlyle Air Tool is warranted against defects in material and workmanship for a period of One (1) Year

Specifications

Overall Length ............................. 7.8"
Width ......................................... 4.13"
Weight .................................... 2.2 lbs.
RPM .................................. 2,600 SPM
Max. material thickness
metal sheet ............18 gauge (1.2mm)
Sound Level ............................ 80dBa
Vibration Level ....................... 1.9m/s2
Air Consumption ................... 3.1CFM
Air Inlet Thread Size .......1/4"-18 NPT
Recommended Hose Size ....3/8" I.D.
Recommended
Air Pressure ................. 90psi (6.2 bar)
Throttle

Air Inlet

5 Rev. 09/09/19