Stamina DT Plus Rower Owner's Manual page 16

COMPUTER INSTRUCTIONS
PROGRAM DESCRIPTIONS
This computer contains 21 different programs. You can preset the program time and the computer will divide
the time into 12 intervals. If you do not set the program time in advance, the computer will use 1 minute for
each interval of Program M (Manual program) and cycle through the program, or the computer will use 3
minutes for each interval for other programs and cycle through the program profile.
(PROGRAM M) MANUAL
PRESET PROGRAMS: Program 1 to Program 14 are preset automatic programs. The profiles are shown
on the face of the computer. Use the " " button to increase the load level of the program. Use the " "
button to decrease the load level of the program.
(PROGRAM 01)
(PROGRAM 04)
(PROGRAM 07)
(PROGRAM 10)
(PROGRAM 13)
MANUAL PROGRAM: This program is a manual program allowing the
user to have full manual control of the workload. Use the "
increase the load. Use the " " button to decrease the load.
(PROGRAM 02)
(PROGRAM 05)
(PROGRAM 08)
(PROGRAM 11)
(PROGRAM 14)
16
" button to
(PROGRAM 03)
(PROGRAM 06)
(PROGRAM 09)
(PROGRAM 12)